7 commissioning, 1 note before commissioning, Commissioning – Siemens Simatic Industrial PC IPC427C User Manual

Page 37

Advertising
background image

SIMATIC IPC427C
Operating Instructions, 04/2009, A5E02414743-01

37

Commissioning

7

7.1

Note before commissioning

Factory state

The SIMATIC IPC427C is available in the following versions:
● With the Windows Embedded Standard 2009 operating system (pre-installed on

CompactFlash card, SSD drive or the hard disk)

● With the Windows XP Professional operating system (pre-installed on SSD drive or the

hard disk)

● Without operating system

Connections before commissioning

Before connecting the device to the power supply, a DVI or CRT monitor should be

connected in order for it to be correctly detected by the BIOS and the operating system

during startup.

CAUTION

Risk of damage to the device
If condensation has developed, wait at least 12 hours before commissioning the device.

NOTICE

Windows Embedded Standard 2009: Read the EWF and FBWF information
Two configurable write filters (Enhanced Write Filter and File Based Write Filter) are

provided with Windows Embedded Standard 2009. Please be aware of this when activating

and using the EWF/FBWF information, otherwise you may experience data loss.

Note
Setting up CompactFlash cards on the employed device
If you want to use CompactFlash cards with the device, they need to be set up on the

device. CompactFlash cards set up on other devices will not boot due to the differing drive

parameters.

Advertising