Graco Inc. 234032 - Manual (Page 11)

Flushing
309523D 11
Flushing
Flush pump and gun before fluid can dry in it. If avail-
able, use flushing procedure provided in your pump or
sprayer manual instead of this procedure.
6.
Trigger gun into solvent pail. Circulate fluid until
system is thoroughly flushed.
WARNING
Read warnings, page 3.
1.
Follow Pressure Relief Procedure, page 6.
Engage trigger lock.
2.
Remove tip guard and spray tip. Clean with sol-
vent. See page 9.
3.
Put the pump intake in a grounded pail of compati-
ble solvent.
T12178A
4.
Start pump at its lowest pressure.
5.
Disengage trigger lock, then trigger gun into the
paint pail. When solvent appears, release trigger.
7.
Follow Pressure Relief Procedure, page 6.
Engage trigger lock.
T12178A